Aleromod.com Aleromod.com

Go Back   Aleromod.com > General Help > Common Questions & Troubleshooting

Reply
 
Thread Tools Search this Thread Display Modes
Old 10-18-2005, 05:09 PM   #1
kenshu
 
Posts: n/a
For some odd reason my 3.4 alero has been idleing from startup at a lil over 2k RPMs. I have already replaced the TPS(Throttle position Sensor) but it still idles high. Even when i drive the idle stay around the 1500 RPM range. Any opinions on what is wrong?
  Reply With Quote
Old 10-18-2005, 05:26 PM   #2
jamcllw
GLS member
 
Join Date: Nov 2003
Location: Dayton
Posts: 1,485
jamcllw is an unknown quantity at this point
probably a vacuum leak somewhere
jamcllw is offline   Reply With Quote
Old 10-18-2005, 06:13 PM   #3
jackal2000
Keepin it Real
 
jackal2000's Avatar
 
Join Date: Nov 2003
Location: Alexandria, VA
Posts: 12,522
jackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond repute
Send a message via AIM to jackal2000 Send a message via Yahoo to jackal2000
yea mine used to do this too, never did figure it out before it stopped. i was told it could be a vacuum leak as well though.
__________________
2015 Audi SQ5
2000 Alero GLS Coupe - still in the family, but I don't drive it anymore
jackal2000 is offline   Reply With Quote
Old 10-19-2005, 12:38 AM   #4
freakout
V.I.P. Member
 
freakout's Avatar
 
Join Date: Mar 2005
Location: Picton, ON, CA
Posts: 476
freakout is an unknown quantity at this point
Same thing happen to me on the weekend. Idling way to high around 2500. Mine was the Idle Air Control Valve. It is located above the TPS. It allows air to bypass the throttle blades to control idle speed. You might want to try a good intake cleaner it might just be carboned up. I was on my way to Chambersburg, PA from up here in the great white north. I think it was around $38 at PEP Boys. Mine didn't throw a code.
__________________

What a great damn day, I can walk!
freakout is offline   Reply With Quote
Old 10-24-2005, 02:16 PM   #5
freakout
V.I.P. Member
 
freakout's Avatar
 
Join Date: Mar 2005
Location: Picton, ON, CA
Posts: 476
freakout is an unknown quantity at this point
Every once in a while mine is staying up around 1250. Don't think it's vacum if I shut the car off and restart it, it returns to normal (750). I thought they were supposed to idle around 600 rpm. Mine is up around 750. All this with no load on engine.
__________________

What a great damn day, I can walk!
freakout is offline   Reply With Quote
Old 10-24-2005, 05:43 PM   #6
jackal2000
Keepin it Real
 
jackal2000's Avatar
 
Join Date: Nov 2003
Location: Alexandria, VA
Posts: 12,522
jackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond reputejackal2000 has a reputation beyond repute
Send a message via AIM to jackal2000 Send a message via Yahoo to jackal2000
mine idles at around 750 normally
__________________
2015 Audi SQ5
2000 Alero GLS Coupe - still in the family, but I don't drive it anymore
jackal2000 is offline   Reply With Quote
Old 10-24-2005, 06:35 PM   #7
Lovestheh20
 
Posts: n/a
what is it when you have a cold start and your idle is bouncing from 1000-1250ish? I get this from time to time.
  Reply With Quote
Old 10-25-2005, 04:55 PM   #8
Fritzee
 
Posts: n/a
Mine was also acting up. Where the idle would act up every once and a while.. I also noticed that if I turned the engine off it would usually reset. I found on one web site some advice that helped. I cleaned the MAF sensor and now it behaves properly. That is actually what brought me to this site. I was looking to see where I found that info because there was some other good info there as well.
Does anyone know some good links for technical help with wiring.
  Reply With Quote
Old 10-27-2005, 11:26 PM   #9
freakout
V.I.P. Member
 
freakout's Avatar
 
Join Date: Mar 2005
Location: Picton, ON, CA
Posts: 476
freakout is an unknown quantity at this point
I'll try cleaning the MAF. It does it warm and cold. Doesn't drop off high idle when it warms up, shut it off, resart and it sits at 750. Start it warm and 1250 restart it's normal. Sometimes you need to restart it a couple of times. Does it maybe once a week. When the IAC valve went it would be as high as 4000 sometimes, but mostly 2000. Did it ever get a kick in the tail going down a hill.
__________________

What a great damn day, I can walk!
freakout is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 10:42 PM.


Powered by vBulletin Version 3.6.0
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.