Needle Kit Install? Easy or Hard

10-13-2006, 12:53 PM

Ok just curious how hard the install is. I got the kit a while ago. And kinda scared to try it

doubleN0alero · 10-13-2006, 01:00 PM

pain in the ass to get the leds to lay flat under the needles, but its doable...been there, done that

10-13-2006, 01:05 PM

Dang dont u have to take the needles off to get to them

Silentalero · 10-13-2006, 01:05 PM

its not as hard, just make sure you recalibrate your needles right...otherwise its just thin wires to be careful with

doubleN0alero · 10-13-2006, 01:07 PM

its not difficult, just a pain in the ass...my speedo was never right after the fact

10-13-2006, 01:10 PM

So im going to mess up my speedo

10-13-2006, 07:13 PM

so my speedo will be messed up bad

strtrydr · 10-13-2006, 10:36 PM

The installation wasn't hard it just took a while...im a neat freak and cautious with the install

I found it impossible to get the underside of the needles to clear the led's but I just trimmed the guage face around the needle hole and it worked perfectly!

EDIT: The calibration of the guages is automatic just got to make sure you record the position of the needle with the key in the "on" position before you take them off...then put them in the on in the same manner with the key in the "on" postion.

10-13-2006, 10:39 PM

any picks of this needle kit.

strtrydr · 10-13-2006, 11:09 PM

importintelligence.com