3400 oil pressure gauge hook up

Even though i dont have a 3400 were do i hook up an oil pressure gauge? Cause on the 2.4 its next to the cam housing and what size are the threads?

[Redog]

On the front of the block on the driver's side.

There is a unit above the oil filter, that is not it. It's the one next to it.

The unit, I believe goes right in without adapters. I t'ed mine with the stock unit and the aftermarket gauge sender

ok thanks alot

[wrestlingandrunning]

Does it matter on what brand of gauge because i have prosport gauges. so no matter what brand of sender it should work right?

[[ion] C2]

it's just a threaded fitting, if it doesn't thread in, get an adapter that fits....

[wrestlingandrunning]

ok thanks!

[cherrington17]

mine needed an adapter. probably depends on company.

[YALEROYNOT]

I replaced the stock one with an autometer one hooked stock wire and auto meter gauge to the same sender. the stock sender is a PITA to get off if I remember I needed a stupid size deep well socket to get it off in one piece. I hammered off the conector and used a reg socket and hoped I didnt need to reuse the stock sender.

nvm found out the answer

[wrestlingandrunning]

would anyone by chance have a picture of where the oil pressure sender hooks up

[Redog]

I may be able to help you out there.

Probably on Monday I'm going back into mine. The header melted the wire to the sender and the gauge goes nuts

[wrestlingandrunning]

Originally Posted by Redog

I may be able to help you out there.

Probably on Monday I'm going back into mine. The header melted the wire to the sender and the gauge goes nuts

hey did you by chance get a picture?

[Redog]

No, I was super busy this past weekend.

Changing the Oil on the 4th, don't have a choice, has the be done, NOW!! I'll get that pic then

[wrestlingandrunning]

ok that works cause i wont get back from vacation till then