P/S Pump removal question

Redog · 11-10-2011, 06:22 PM

I know it's 3 bolts holding it on the block (or bracket) However according to the repair guide on Autozone's website, removal of the upper motor mount is required.

I know I have to remove the crusie control box and belt to get it off, but can anybody confirm if I do have to remove the motor mount as well. Depending on removal of the mount or not, really depends on where I do the work at. All my heavy tools like that are at my mom's house.

I need to replace the 7X CPS

alerored04 · 11-10-2011, 06:47 PM

The mount must come off. Otherwise you cannot raise the engine to reach the bottom bolt.

cavaliers60 · 11-10-2011, 06:58 PM

Just replaced this myself... Motor mount comes off, unscrew the three bolts, then slap the new one on. Was a piece of cake.

Redog · 11-10-2011, 10:54 PM

Guess I'm doing this at Mom's house

MMGT1 · 11-11-2011, 10:47 AM

I need to do the same job Red. Also want to put in new chain and guide so I'm planning both jobs at the same time when I can get a day to do it. Hurt my dam back last week and I'm laid out on the couch right now....sucks...lol

SIUlero · 11-15-2011, 12:10 AM

Actually, you can get to it by just removing 1 of the bolts from the mount, but it's a hell of a struggle. It's alot easier if you just remove the top bolts from the mount and jack up the engine with a block of wood to get access to that last pump bolt...the mount doesn't have to be completely removed.