RMS Question

[Cashdollar2009]

Originally Posted by Ryan from Ohio

When you bend ports the port length is measured from the center of the port, not a port wall side.

So it would start in the center of the port at the front of the box. Not 3/4" in...

Im gonna guess neither of you realized this.

Sure you can build it as shown, but the tuning would be off. Depends on how accurate you want to get...

Referring to me?

[Afugy]

Originally Posted by Cashdollar2009

Referring to me?

ROFL, he wasn't talking to me.

[Ryan from Ohio]

Originally Posted by Cashdollar2009

Referring to me?

Yes. Since you called out 19" and he went 19" along one edge and wasnt corrected.


Either you didnt know it or missed it.

I miss shit all the time so dont feel bad!

[Bigshot44]

hopefully this will be my last diagram. hows it look?



thanks again for the help.
and going back to the beginning of the thread i cant use either of those amps cause theres no way to get them running at 3 ohms :/
are there any other options other than the JL 1000/1v2

[Ryan from Ohio]

That port MUST be 3" off the back wall.

Why cant you use either of the amps?

If the amps are stable to 2 Ohms bridged or less then you can.

You wont find amps rated at 3 ohms.

[scott192]

i ran a w7 om my mrp-m2000 at 3 ohm worked great!

[Bigshot44]

how would you wire the amp into a 3 ohm load?

[Ryan from Ohio]

Both + leads into the positive and both negs into the neg.