|
installing shiftplus
bought B&M Shiftplus recently and intend on installing it ASAP. i dont have any problems with the wiring, there is a very nice how to on here. my problem is where and how do i get the wire from inside the cabin, to outside, in the engine bay? ive searched and seen a few things about a hole or grommet or something in the firewall on the drivers side, but havent had much luck locating this. also, to mount it somewhere inside (center counsol, under dash etc) what has to be taken off (trim) to get the wire to the previously mentioned firewall hole? ive searched every thread on here for a little bit more info, and cant seem to find it. if someone could help me out that would be great. if someone does find a thread with directions, just let me know, and i apologize in advance. thanks.
|
Linear Mode
