Need Rocker Arm and Pushrod seating help

I'm in the process of doing the LIM felpro gasket switch and I got the exhaust and intake pushrods mixed up, if anyone could tell me exactly which pushrods go to the 12 lifters and for the rocker arm seating...they look exactly the same when you turn them 180 degrees so how do you know which way to seat the rocker arms?

The only thing i could see is there's one little dot on the very bottom of the rocker arm on one side of the bolt but not sure if this means anything.

[alerored04]

that little indent is the seat for the pushrod. Ill let someone else tell you where each rod goes though, i cant remember that too well.

yea i can fit the rocker arm in the indent but if you flip it around 180 degrees it will fit too...just trying to figure out if there's only 1 way to do it right or if i can just throw the rocker arms in and its no problem

[rustyballs_69]

I believe that the ones for your exhaust valve are shorter than your intake rods. I got two of mine mixed up and when i put them in the rocker was loose as a goose on one. glad a fixed that before i put it all back together.