tps wiring diagram

[sleepyalero]

Does anyone have a picture showing where the tps wiring runs to? I keep getting stupid low voltage/curcuit codes for my tps through HPT. And I need to trace the wiring from the tps all the way back to the pcm to see if wiring is damaged and it would be easier if I just had a picture to run off of instead of fiddle with huge amounts of wire.

If anyone has something. Thanks!

Ive replaced the tps numerous times with no fix. And even added a new pigtail for the tps also with no fix. So right now I cant tell if its the pcm that is bad or somewhere in the system wiring is messed up...

[sleepyalero]

Also. If its a bad pcm is there a way I could buy a new one. Then transfer my things from old pcm to new one without paying 100$ to write a tune to it?

[MMGT1]

You would have to buy two more credits unfortunately. I may have diagram... give me a couple here

[MMGT1]

black pcm#29
dark blue #16
gry/black #15
I would start by tracing that sensor ground wire. "Wiggle" the wire while you scan the car and watch the TPS closely. Prop the throttle open so its reading 100% when you go fishing for the fault

[sleepyalero]

Well I just picked up a new pcm about 5 mins ago and im going to try that first. Cost me close to nothing so no big deal.

The pcm is above the pedals on driver side of car right?

[MMGT1]

Yup, to the left of pedals actually. Clip holds it up in place, it will slide down, pull carpet back to give yourself a little room to work

[sleepyalero]

Okay yeah then I got it lol and paul I hooked up the computer. Pedal to the floor. And wiggled wires up until it shoot down behind fuse box. And the tps % and voltage did not change.

[MMGT1]

Only thing now is to test it to see if the TPS fails with new pcm in it driving

[sleepyalero]

Right. Paul I sent you a pm. Please reply. :)

[MMGT1]

PM'd

[sleepyalero]

Thanks buddy. I will give you an update tomorrow after I swap pcms and change everhthing to find out if I fixed the issue.

[sleepyalero]

paul, i sent you an email.