Center Colsole

[Xtrm]

I would like to know how I go about taking out my center console. Everything from the dash to the gear shifter.

[Caboose73]

unscrew the screws that are holding it in place

[jayson_waltz]

-2 screw un front by your feet right under where the dash meets is.
-2 screw inside the center console, take the bottom rubber mat out.
-2 screws b/t the seat and the console, on the side and closer to the back. slide the seats back all the way and you can get them.
-Pry out the u shaped pin on the front of the shifter. pull shifter up and off.
-pry (well, pop) off the trim around the bottom of the shifter. unhook trac button wire and bulb for shift indicator. lift out
-pull out center consloe up and towards back seat.

you will need a 1/4 inch rachet, forget what size socket, but all the screws are the same size, a long extension to reach into the center console hole, and a regualr size flat blade screw driver.

that help?

[Nate's Alero]

-2 screw un front by your feet right under where the dash meets is.
-2 screw inside the center console, take the bottom rubber mat out.
-2 screws b/t the seat and the console, on the side and closer to the back. slide the seats back all the way and you can get them.
-Pry out the u shaped pin on the front of the shifter. pull shifter up and off.
-pry (well, pop) off the trim around the bottom of the shifter. unhook trac button wire and bulb for shift indicator. lift out
-pull out center consloe up and towards back seat.

you will need a 1/4 inch rachet, forget what size socket, but all the screws are the same size, a long extension to reach into the center console hole, and a regualr size flat blade screw driver.

that help?

Rep Given, great how to!

[Ian 2000GL LA1]

just use an hammer and a flat head screwdriver. JK.

[Caboose73]

Rep Given, great how to!

what no rep for me?