Front Mount Plate Torque?

[Pacho]

I changed my drive belt tonight and noticed you have to support the engine by jack because to get the belt out, you need to remove the front mount plate. The front mount plate is right besides the coolant reservoir, with 2 bolts that are 18mm and 2 that are 15mm. What is the specific torque for these 4 bolts?

I tested the torque of them originally but I think they were a little loose, 70 lbs for bigger bolts, and it was at 60 lbs for the 15mm before i took the plate off.

[rustyballs_69]

The book doesn't say anything about the torque specs for the motor mount bolts.

[CactusWill]

Yeah this is more or less a common sense type deal and use yourself some blue threadlock for good measure.

[Pacho]

yea that's what i figured since it wasnt in my haynes manual it must not be that important to worry about. appreciate it.

[super white alero1]

Engine Mount Bracket Bolts
Note: (Right Hand Side) 99 ft.lb
Engine Mount To The Body Support Nut
Note: (Right Hand Side) 49 ft.lb
Engine Mount To The Engine Mount Bracket Bolts
Note: (Right Hand Side) 46 ft.lb

You're welcome.

[Blktrax]

Snap On 1/2" impact gun, * Brap - Brap* done.

[Pacho]

Engine Mount Bracket Bolts
Note: (Right Hand Side) 99 ft.lb
Engine Mount To The Body Support Nut
Note: (Right Hand Side) 49 ft.lb
Engine Mount To The Engine Mount Bracket Bolts
Note: (Right Hand Side) 46 ft.lb

You're welcome.


where'd you get these from? thanks bro

[super white alero1]

@ Pacho, AllData Pro.