Alerosaint
05-28-2008, 01:47 AM
For those who have the mp45 kit or done an install with one I have a question. My install was going pretty good until I put on the the intake manifold/charger...for when I put it on I realized the intake manifold would not seat because the two bottom post was blocking the intake from seating properly...how did you guys get around this??? Do the posts come out then you put on the supplied bolts?? My bad if im being noob slow but I did have a long day. Appreciate any input. Thx
4302
Just a visual of the two post at the bottom..6 and 7
4302
Just a visual of the two post at the bottom..6 and 7