montana_GX
03-14-2007, 03:49 PM
I've been doing some research on a problem with my alero, and I came across a TSB put out by GM on APR 1, 2004. Well actually, I could only read a small piece of it, and i would like to read the whole thing. Does anyone on here know how to get ahold TSB's from GM??? I've looked online and everywhere i check wants me to pay for them. Will a dealership let me see one if i ask?? IF ANYONE ON HERE WORKS FOR A DEALER AND WANTS TO HELP the TSB number is 040604024. The NHTSA ID is #10012634, and it starts with "the pcm will not properly communicate......." that's all i get.
thanks for ANY help in this...
Alero 2 Envy
03-14-2007, 04:23 PM
http://www.carcomplaints.com/Oldsmobile/Alero/1999/tsbs.shtml
montana_GX
03-14-2007, 04:34 PM
ya that's where i found the first part...i was lookin for the WHOLE thing
Pimpalero03
03-14-2007, 06:54 PM
Document ID# 1491672
http://service.gm.com/engif/000/999/999/999999995.gif Subject:Powertrain Control Module (PCM) Will Not Properly Communicate On-Board Diagnostic Freeze Frame Information to Non-Tech 2 Service or Test Equipment (Reprogram PCM) #04-06-04-024 - (04/07/2004)
Models:2001-2002 Buick Century, LeSabre, Park Avenue, Regal 2002 Buick Rendezvous
2001-2002 Chevrolet Impala, Malibu, Monte Carlo, Venture
2001-2002 Olsmobile Alero, Aurora, Intrigue, Sillouette
2001-2002 Pontiac Aztek, Bonneville, Grand Am, Grand Prix, Montana
with 3.1L, 3.4L, 3.5L, or 3.8L V6 Engine (VINs J, E, H, K, 1 - RPOs LG8, LA1, LX5, L36, L67)
<A href="http://service.gm.com/servlets/BlobShtml?ShtmlFile=1491672&evc=numSrch#ss1-1491672">Condition
Some customers may comment that their vehicle's engine is unable to be properly serviced or tested using non-TECH2® (Generic) service or test equipment. When requested using non-TECH2® (Generic) service or test equipment, these vehicles are unable to properly communicate diagnostic freeze frame information.
<A href="http://service.gm.com/servlets/BlobShtml?ShtmlFile=1491672&evc=numSrch#ss2-1491672">Correction
Reprogram to the latest calibration available through TIS.
The new calibration should be from TIS satellite data update version 1.0 for 2004 or later, available starting January 2004. As always, make sure your TECH2® is updated with the latest software version.
<A href="http://service.gm.com/servlets/BlobShtml?ShtmlFile=1491672&evc=numSrch#ss3-1491672">Warranty Information
For vehicles repaired under the applicable 8 year 80,000 mile (130,000 kilometres) emission controller warranty, use:
Labor Operation
Description
Labor Time
J6353
Module, Powertrain Control -- Reprogram
All Except Park Avenue, Bonneville
0.4 hr
Module, Powertrain Control -- Reprogram
Park Avenue, Bonneville
0.5 hr
GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.
http://service.gm.com/engif/000/999/999/999999994.gif WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION
© Copyright General Motors Corporation. All Rights Reserved.
vBulletin v3.6.0, Copyright ©2000-2025, Jelsoft Enterprises Ltd.