Spark Plug Wires

[CiscoPath]

Take into account that this is my first performance upgrade and Haynes was no help:

I have my Taylor 8mm Spiro Pros and just bought the wire puller tool (wanna do it right). The front 3 are easy enough but I can't even see the ones on the rear. Am I supposed to remove something?

[billytheman1188]

No, its hard to reach back there, but i did it. Just be patient, i did it with my hands, so u can deff do it.

[AGT]

yep...back three are a bitch...and just wait until you actually changes the plugs themselves

[jackal2000]

after you change them once its a cinch. just gotta get a feel for where everythings at back there. it also helps to be over 6' tall. :)

i have never used a wire puller but i did manage to rip one of the stock wires in half when i was replacing with MSD ones. oops!

[AGT]

6 foot helps but I think your little hands did the trick haha j/k ^^

[alerored04]

being tall with long arms definately helps. Just kinda feel around and figure out where everything goes. Its pretty easy. And just in case you didnt realize it yet, dont pull all the stocks at once. do one at a time, that way you cant run the wires to the wrong plug. Just thought id let you know since you said its your first perf mod.

[CiscoPath]

Luckily, i'm 6' and have long arms, so I'm gonna pop the hood tomorrow morning and see what i could do. And if i can do it without the tool, i'm getting my ten bux back for it. Appreciate all the help, guys. I'll let ya know how it goes