Upper motor mount?

[Redog]

I've been looking around off and on since ASS, I found the lower one (aka Tranny mount) but I know I've seen the "Dog Bone" upper mount somewhere.

I see it all over for the 2200, 2.4 and the 2.2 eco, but does it exist for the 3400? Does the 2.4 "Dog Bone" fit? Somehow I doubt it.

Really I shouldn't even be looking. Cash flow is low, due to the wedding, and I just dropped $510 for Delta exhaust :cry:

[BlackJack]

contact these guys and see if this will work for you.

http://www.unitedmalibus.com/mpracing/enginebrace.html

[alerored04]

curious if anyone had more info on this. My mounts are pretty shot (The ones on the side by the belt and there is one on the other side i believe) and im lookin for some better ones. Any ideas? The mp racing one looks like an additional brace if im not mistaken.

[Redog]

^ Got a link?

[BlackJack]

contact these guys and see if this will work for you.

http://www.unitedmalibus.com/mpracing/enginebrace.html

that was the link, right above his post...

[alerored04]

I meant this one. and the other side if there is one, i havent looked to closely at the drivers side though. The rubber mount is beginning to show signs of cracking and is very loose. Like loose enough that i can move it around with my hand, it is that soft. Im trying to find out if there is a performance version of this mount available and to see if this should be replaced because of the condition it is in.

[BlackJack]

ah, ok...I'm going to be making my own with liquid Urethane (sp?). Somewhere on 60degreeV6.com was an article on it. Much more solid by the feedback on em. Other than that, the only ones I've heard of is MMS which like the rest of their products are overpriced.

[jackal2000]

MMS does not offer a "dog bone" mount, only the tranny mount.

[alerored04]

blackjack when you do that make sure to do a write up on it.

[BlackJack]

k bro, will do.

[alerored04]

thanks man.