PDA

View Full Version : 2 Minor Problems

Menace
03-14-2006, 06:42 PM
1. Gauge needles wont light up ( i think its a bulb behind my cluster?)
2. Low tire pressure light wont turn off ( I know there is a reset button for oil and tire pressure but I pressed it and held it and it still did not reset, should I hold it for a longer time, is there somthing else I need to do?)
CTS21
03-14-2006, 08:39 PM
I believe that you have to push the button once then pick the one that is on and then hold it till it beeps. Check your manual it should tell you.
Menace
03-14-2006, 09:08 PM
what about the needle ?
derek_ski99
03-14-2006, 09:10 PM
did you bump the dial to dim your lights per chance? i know its kind of obvious but sometimes its those kinds of things you overlook.
natedawg9640
03-14-2006, 09:29 PM
to use the reset button you have to hit it untill the selection you want to cancel is flashing... then hold it in until it beeps...
Menace
03-14-2006, 10:23 PM
Lemme go check those things out I may have bumped my dial actually.
Menace
03-14-2006, 10:27 PM
LOL he was right about the dimmer but as much as I press the reset button it never makes the low air pressure light blink or anything.
dustyd63
03-14-2006, 10:53 PM
The reset switch is in the fuse panel -- turn the car off and back to on, then press the reset button until the Low tire pressure light flashes... (Sometimes you have to press it repeatedly, not just hold it in)... and then hold it in - the chimes should sound and the light should disappear.

(It took me forever to figure it out. The old VCR programmers must have struck again.)
Nik1128
03-14-2006, 10:54 PM
Well, the ignition has to be on, but the engine can't be running.. you then tap the reset button once until the tire pressure light flashes, then you hold the reset button down until the car dings. Then it'll go off.

**edit; You beat me to it, dustyd63. :P
Menace
03-14-2006, 11:03 PM
K, I had the ignition on, ill try it out tommorow morning. Thanks everyone.
Menace
03-15-2006, 08:48 AM
I put my car on acc and the reset button worked awsume. You press it and the oil or low tire pressure will blink, matters how many times u press reset. Once your desired light is blinking you hold reset and it will chime a few times then once the chimes are done you can let go and the light will go off.