PDA

View Full Version : Ported Intakes

jabartram
02-05-2006, 11:55 AM
are we limited to Donkey Punch, Milzy, and Apoc now? RSM and Doctor speed dont list them anymore?
-Alero-
02-05-2006, 10:21 PM
i was about to ask the same question.
Fast Eddie
02-06-2006, 02:50 PM
NO, your talking the stock manifolds right? Just pull em off and take an alum bit to em and port em out. sand it smooth and then clean it all up. Its not the difficult. The hard part is taking the parts off.
-Alero-
02-07-2006, 09:19 PM
i thought some of the places actually put in an affort to smooth out the pathways?
jabartram
02-07-2006, 09:37 PM
Originally posted by Fast Eddie@Feb 6 2006, 02:50 PM
NO, your talking the stock manifolds right? Just pull em off and take an alum bit to em and port em out. sand it smooth and then clean it all up. Its not the difficult. The hard part is taking the parts off.
Quoted post


if i had an extra set i would, i'm keeping an eye on ebay.
O1gagt
02-08-2006, 12:23 PM
The 60degreeV6 store sells them as well.

http://60degreev6.com/store/index.php?act=...03443df4ecb4bb6 (http://60degreev6.com/store/index.php?act=viewCat&catId=10&ccSID-285e73f64c04744fc5f33ff68f529742=a3b6c49bbfc8bc73f 03443df4ecb4bb6)
-Alero-
02-09-2006, 09:58 PM
" Fuel injector port is NOT cut down, which can lead to worse fuel distribution into the port and air/fuel mixture. Airflow is not increased by removing the injector boss fin either."

^^wtf does that mean!?